Storm door installation instructions

EasyHang® Installation Steps: Step 1: Tools Needed & Determine Hinging. Step 2: Set Placeholder Screw for Hinge Rail. Step 3: Storm Door Expander. Step 4: Attach Hinge Rail to Storm Door. Step 5: Attach Storm Door to Door Frame. Step 6: Install the Drip Cap. Step 7: Install Latch Rail. Step 8: Install Handle and Strike Plate. Step-by-Step Storm Door Installation. Drill pilot holes in the storm door. 1 Place the door interior side up, and position the vertical hinge mounting frame on the hinge side so that the top of the track extends beyond the door by 3/32 inch. Then drive one mounting screw through the hinge into the pre-drilled hole in the door. Get step-by-step instructions to installing a screen door or a storm door at your home. Explore storm door installation information from Pella. Screen door closers are typically installed on bottom, but can be installed on top if desired, although wind chain could be in the way. Always install on interior side of storm door; install on edge with hinges. If door frame is steel instead of wood, a commercial door closer is required; this one will not work. The storm door has a frame that must be installed to the brick molding of the exterior door. Measure the door opening from top to bottom and cut the hinge frame to fit the opening. Have a helper hold the door while you attach the frame to the brick molding. Make sure that the door is plumb, and check to make sure that it will close properly. 202220580 PATIO STORM DOORS 3 FRAME ASSEMBLY BEFORE PROCEEDING:If the optional sill leg is being used, install it in the sill before screwing the frame together (Figure 7). Note the correct position of the sill leg. 1. For ease of assembly, position the right jamb, left jamb, head, and sill according to the "Assembly and Installation" STEP 3: Hang the storm door. With the door in a closed position, place it in the opening and push the hinge side of the door tightly against the door jamb, making sure that the top of the hinge Use the provided 5/32-in Allen wrench to loosen the set screw in the pad closest to the hinges in the drip cap. Move the pad toward the handle side to the desired hold-open position and tighten the set screw. DO NOT MOVE THE PAD TOWARD THE HINGES. HOW-TO GUIDE. To hold the door in the open position using a standard closer, open your door and slide the washer along the closer rod until it is located behind the closer cylinder. When the door panel is released, the cylinder will rest against the washer to hold the door in the open position. Operating a Push Button Closer on Storm Door Wood Core Storm Door Owner's Guide and Installation Manual. 202220979. Storm Door Components. NOTE: Actual door styles may vary from illustrations, however, the installation steps will be the same. These instructions depict a Right Hinge installation unless otherwise noted. painted Qty: 1: 3: 3A: Place interior side up. 3C: storm door unit is installed. Contact dealer or Customer Service with pictures and order number for replacement parts. 5 For all storm doors, EXCEPT Spectrum models, remove blue shipping tape. Then remove all sash and screen inserts. Carefully set aside until after storm door installation. (Fig. A.2) NOTE: For Deluxe™, DuraGuard™, and 4. Do not operate the storm door without closer(s) installed and adjusted to prevent door slamming. 5. Eye protection must be used during the installation to prevent injury from flying particl